KSB Amacan K - Submersible motor pump with non-clogging impeller

 

 

Design

KSB-Amacan K-ModularKSB Amacan K – Wet-installed submersible motor pump with non-clogging impeller, singlestage, single-entry, for installation in discharge tubes, explosion protection to ATEX II G2 T3.

 

 

 

 

 

 

 

 

 

Applications

Handling of pre-cleaned, chemically neutral waste water, industrial effluents and sewage, fluids not containing any stringy substances pre-treated by screens and sills, as waste water, mixed water and activated sludge pump in effluent treatment plants, irrigation and drainage pumping systems.

Function

KSB-Amacan K-instThe fluid enters the pump axially via the inlet of the pump casing (1) and is
accelerated outward in a radial flow by the rotating impeller (2). The required energy
is transmitted from the electric motor (7) to the impeller (2) via the shaft (4). In the
pump casing (11) the kinetic energy of the fluid is converted into pressure energy.
The rotational movement diverts the fluid flow in axial direction. The casing wear
ring (12) prevents any fluid from flowing back from the casing into the inlet of the
pump casing. At the rear side of the impeller, the shaft enters the casing via the
discharge cover (3). The shaft passage through the discharge cover is sealed towards
the fluid by a shaft seal (10). The shaft runs in rolling element bearings (5 and 8),
which are supported by a bearing housing (9) and a bearing bracket (6).

 

 

Standard

KSB-Amacan K-Diagram Temperature monitoring of the motor
▪ Temperature monitoring at the lower bearing
▪ Leakage monitoring of the mechanical seal system
▪ Leakage sensors in the motor/connection space

 

 

 

 

 Flamepaths for explosion-proof motors

KSB-Amacan K-Explosion proof

 

 

 

 

 

 

 

 

 

 

Overview of technical data

Type of bearing Rolling element bearings
Casing partition Radially split
Drive Electric motor
Drive frequency 50 Hz / 60 Hz
Type of drive Electric motor
Drive voltage Low voltage
Connection to power supply 380 V, 400 V, 690 V, 3~
Explosion protection ATEX II 2G T3
No. of impeller entries Single entry
Impeller material (EN standard) 9. 4460;JL 1040
Type of installation Close- coupled
Type of coupling None
Type of lubrication Grease lubrication
Max. permissible fluid temperature 40 °C
Nozzle position In- line
Pump set location Wet well
Shaft material (EN standard) 1. 4021QT700;C45+N;1.4057
Suction characteristics Non- priming
Type of casing Tubular casing
Type of impeller Multi- vane impeller;Radial;Closed
Casing material (EN standard) JL 1040
eClass assignment 36410103; 36410100;36410000
Free passage 180 mm
Maximum head 30, 00 m
Minimum head 1, 00 m
Installation position Vertical
Shaft seal type Mechanical seal
Main applications Water; Waste water / sewage;Mining / Dredges
Casing material Cast iron
Maximum drive rating 320 kW
Type of installation Stationary
Maximum flow rate 7. 200 m³/h
Minimum flow rate 140 m³/h
Maximum speed of rotation 1. 200 1/min

 

EBARA              GRUNDFOS               KSB              WILO             TSURUMI

Related posts

Leave your comment

Your Name: (required)

E-Mail: (required)

Website: (not required)

Message: (required)

Send comment